The DR-070 Robot is equipped with a X and Y-axis and 2 Z-slide modules. On these Z-slides are one DD-5130 needle valve and one DD-5140 round spray narrow bean valve mounted. If rotation and tilt is required the Z-axis can be upgrade to Z-axis with rotation and tilt. The DR-070 has one free slot left to install an extra Z-slide module with or without rotation axis. If installing 3 Z-slides only 2 of them can be Z-slides with rotation and tilt. Z-slides connect through a connector locating the unit in place. When the Z-slide is placed it only needs to be secured with a few screws. After plugging in the air and material tubes the unit is ready for use. The units can be configured outside the machine.
The DR-070 comes with
a computer with DIMASOFT user software,
a base for up to 3 Z-slides,
one electronic pressure sensor for the main air supply,
one sensor and regulator for material pressure and
one sensor and regulator for atomising air.
A sensor for detection of exhaust air is as an option available (required for solvent based coatings).
The robot comes as a batch machine but can be upgraded to an in-line machine. All these features make the Elite selective conformal coating Robot DR-070 the most flexible to configure and easy to reconfigure robot available for fast selective conformal coating jobs. Together with the unbeatable DIMA Easy track® offline programming software and the DIMAsoft User interface DIMA has created the ultimate machine